步进电机c程序 -

*
* STEPPER.C
* sweeping stepper's rotor cw and cww 400 steps
* Copyright (c) 1999 by W.Sirichote
*/

#include c:\mc51\8051io.h/* include i/o header file */
#include c:\mc51\8051reg.h

register unsigned char j,flag1,temp;
register unsigned int cw_n,ccw_n;

unsigned char step[8]={0x80,0xc0,0x40,0x60,0x20,0x30,0x10,0x90}
#define n 400

/* flag1 mask byte
0x01run cw()
0x02run ccw()
*/

main()

{
flag1=0;
serinit(9600);
disable();/* no need timer interrupt */
cw_n = n;/* initial step number for cw */
flag1 |=0x01; /* initial enable cw() */

while(1){
{
tick_wait();/* wait for 10ms elapsed */

energize();/* round-robin execution the following tasks every 10ms */
cw();
ccw();
}
}

}

cw(){
if((flag1&0x01)!=0)
{
cw_n--;/* decrement cw step number */
if (cw_n !=0)
j++;/* if not zero increment index j */
else
{flag1&=~0x01; /* disable cw() execution */
ccw_n = n;/* reload step number to ccw counter */
flag1 |=0x02; /* enable cww() execution */
}
}

}

ccw(){
if((flag1&0x02)!=0)
{
ccw_n--;/* decremnet ccw step number */
if (ccw_n !=0)
j--;/* if not zero decrement index j */
else
{flag1&=~0x02; /* disable ccw() executon */
cw_n = n;/* reload step number to cw counter */
flag1 |=0x01; /* enable cw() execution */
}
}

}

tick_wait(){/* cputick was replaced by simpler ASM code 10ms wait */

asm" JNB TCON.5,*";/* wait for TF0 set */
asm" CLR TCON.5";/* clear TF0 for further set */
asm" ORL TH0,#$DC";/* reload TH0 with $DC, TL0 = 0 */
}

energize(){

P1 = step[(j&0x07)];/* only step 0-7 needed */
}

本文引用地址: http://www.21ic.com/app/mcu/201809/785358.htm